38
YASKAWA
TOEP C720600 11B External Heatsink Installation Kit Installation Manual
◆
Gasket and Sealant
If the environment around the heatsink does not meet the recommendations for the drive
installation environment, install a gasket or apply sealant as shown in
and
. Make sure that the drive is safe from unsatisfactory environmental conditions.
Use a gasket that is approximately 2 mm (0.08 in) thick and made from CR or an EPDM-based
rubber sponge.
Yaskawa recommends these products:
•
Gasket: INOAC CORPORATION C-4205
•
Sealant: Shin-Etsu Silicone KE-3494 from Shin-Etsu Chemical Co., Ltd.
The gasket must have a width of 7 mm (0.28 in) or more around the opening. Refer to
Mounting Dimensions and Panel Cut-out Dimensions on page 9
for more information.
A - Enclosure panel
B - Gasket
C - Mounting screws
Figure 5.47 Install a Gasket
