28
YASKAWA
TOEP C720600 11B External Heatsink Installation Kit Installation Manual
■
Use the Mounting Bracket Included with the Drive and the Kit (Procedure C)
Use the figures in this procedure to make sure that the orientation is correct, then install the
mounting bracket and the kit to the drive.
Cut an opening in the enclosure panel before you install the kit. Refer to
Dimensions and Panel Cut-out Dimensions on page 9
for more information.
1.
Remove the mounting bracket from the bottom of the drive.
Note:
You will not use the removed screws for installation.
A - Mounting bracket
B - Screws
Figure 5.29 Remove the Mounting Bracket
2.
Use the screws included with the kit to install the removed mounting bracket to the
bottom of the drive in the position shown in
Tighten the screws to a correct tightening torque:
• M6
×
12 pan head screws: 3.92 N
∙
m to 4.90 N
∙
m (34.70 lbf
∙
in to 43.37 lbf
∙
in)
A - Mounting bracket
B - M6
×
12 pan head screws
Figure 5.30 Install the Mounting Bracket (Bottom of the Drive)
3.
Use the screws included with the kit to install bracket 2 to the top of the drive in the
position shown in
Tighten the screws to a correct tightening torque:
• M6
×
12 pan head screws: 3.92 N
∙
m to 4.90 N
∙
m (34.70 lbf
∙
in to 43.37 lbf
∙
in)
