13.6 TIA Portal - Deployment PG/OP communication - PROFINET
–
With firmware version V2.4.0, there is a PROFINET IO controller
available via the Ethernet PG/OP channel.
–
As soon as you use the PROFINET functionality via the Ethernet
PG/OP channel, this affects the performance and response time of
your system and due to the system the cycle time of the OB 1 is
extended by 2ms.
13.6.1
Deployment as PROFINET IO controller
13.6.1.1
Steps of configuration
Range of functions
Please regard that the PROFINET IO controller supports only the
PROFINET functions, which are described in this manual, even if the Sie-
mens CPU, which is used for configuration, offers further functions! To
use some described PROFINET functions, it is necessary to deploy
another Siemens CPU for configuration. Here, however, is pointed to
explicitly.
The configuration of the PROFINET IO controller for PROFINET communication should
be done by the following procedure:
1.
Commissioning and Initialization (assignment IP address data)
2.
Hardware configuration - CPU
3.
Configuration PROFINET IO controller
4.
Configuration PROFINET IO device
With the Siemens TIA Portal, the CPU 013-CCF0R00 from VIPA is to be
configured as
CPU 314C-2 PN/DP (314-6EH04-0AB0 V3.3)!
13.6.1.2
Commissioning and initialization
1.
Install your System SLIO with your CPU.
2.
Wire the system by connecting cables for voltage supply and signals
3.
Connect your PROFINET IO controller with Ethernet.
4.
Switch on the power supply.
ð
After a short boot time, the CP is in idle.
At the first commissioning respectively after an overall reset of the CPU, the
PROFINET IO controller and the Ethernet PG/OP channel have no IP address.
Assembly and commis-
sioning
VIPA System SLIO
Configuration with TIA Portal
TIA Portal - Deployment PG/OP communication - PROFINET > Deployment as PROFINET IO controller
HB300 | CPU | 013-CCF0R00 | en | 19-30
305