YASKAWA SGM series, Safety Precautions, Page: 7 / 35

• Do not install or store the product in any of the following locations.
• Although machined surfaces are covered with an anticorrosive coating, rust
can develop due to storage conditions or the length of storage.

If you store the product for more than six months, reapply an anticorrosive
coating to machined surfaces, particularly the motor shaft.
• Consult with your Yaskawa representative if you have stored products for an
extended period of time.
• Transport the product in a way that is suitable to the mass of the product.
• Do not hold onto the cables or motor shaft when you move a Servomotor.
• Do not use the eyebolts on a SERVOPACK or Servomotor to move the
machine.
• When you handle a SERVOPACK or Servomotor, be careful of sharp parts,
such as the corners.
• Do not place an excessive load on the product during transportation. (Follow
all instructions on the packages.)
E-5

Transportation Precautions
NOTICE
• Locations that are subject to direct sunlight
• Locations that are subject to ambient temperatures that exceed product spec-
ifications
• Locations that are subject to relative humidities that exceed product specifi-
cations
• Locations that are subject to condensation as the result of extreme changes
in temperature
• Locations that are subject to corrosive or flammable gases
• Locations that are near flammable materials
• Locations that are subject to dust, salts, or iron powder
• Locations that are subject to water, oil, or chemicals
• Locations that are subject to vibration or shock that exceeds product specifi-
cations
• Locations that are subject to radiation
If you store or install the product in any of the above locations, the product
may fail or be damaged.
CAUTION
There is a risk of disconnection, damage, or injury.
There is a risk of damage or injury.
There is a risk of injury.
There is a risk of injury or damage.