YASKAWA Lift Inverter L1000V, Technical Manual

Page: 31 / 282

2.2 Mechanical Installation
YASKAWA EUROPE SIEP YASKAWA AC Drive L1000V Technical Manual 31
Mec
h
an
ic
al
In
st
al
lat
io
n
2
2.2 Mechanical Installation
This section outlines specifications, procedures, and the environment for proper mechanical installation of the drive.
CAUTION! Crush Hazard. Carrying the drive by the front cover may cause the main body of the drive to fall, resulting in minor or
moderate injury. Always hold the case when carrying the drive.
u
Installation Environment
For optimum performance life of the drive, install the drive in an environment that meets the conditions listed below.
Table 2.1 Installation Environment
NOTICE: Avoid placing drive peripheral devices, transformers, or other electronics near the drive as the noise created can lead to
erroneous operation. If such devices must be used in close proximity to the drive, take proper steps to shield the drive from noise.
NOTICE: Prevent foreign matter such as metal shavings and wire clippings from falling into the drive during installation. Failure to
comply could result in damage to the drive. Place a temporary cover over the top of the drive during installation. Remove the
temporary cover before startup, as the cover will reduce ventilation and cause the drive to overheat.
u
Installation Orientation and Spacing
WARNING! Fire Hazard. Provide sufficient cooling when installing the drive inside an enclosed panel or cabinet. Failure to comply
could result in overheating and fire. When drives are placed inside the same enclosure panel, install proper cooling to ensure air
entering the enclosure does not exceed 50
°
C.
n
Installation Orientation
Install the drive upright as illustrated in Figure 2.1 to maintain proper cooling. Refer to Mechanical Installation on
page 31 for details on installing the drive.
Figure 2.1
Figure 2.1 Correct Installation Orientation
Environment Conditions
Installation Area Indoors
Ambient Temperature
-10 °C to +50 °C (IP20 enclosure)
-10 °C to +40 °C (IP20 / NEMA Type 1 enclosure)
Drive reliability improves in environments without wide temperature fluctuations.
When using the drive in an enclosure panel, install a cooling fan or air conditioner in the area to ensure that the air temperature inside the enclosure
does not exceed the specified levels.
Do not allow ice to develop on the drive.
Humidity 95% RH or less and free of condensation
Storage Temperature -20 to +60 °C
Surrounding Area
Install the drive in an area free from:
• oil mist and dust
• metal shavings, oil, water or other foreign materials
• radioactive materials
• combustible materials (e.g., wood)
• harmful gases and liquids
• excessive vibration
• chlorides
• direct sunlight
Altitude 1000 m or lower, up to 3000 m with derating (Refer to Drive Derating Data on page 220 )
Vibration
10 to 20 Hz at 9.8 m/s
2
20 to 55 Hz at 5.9 m/s 2
Orientation Install the drive vertically to maintain maximum cooling effects.
OK Not OK Not OK