YASKAWA LA500, Technical Manual

Page: 112 / 376

5.2 European Standards
112 YASKAWA SIEPYEULA5001C LA500 Technical Manual
5.2 European Standards
Figure 5.1 CE Mark
The CE Mark identifies that the product meets environmental and safety standards in the European Union.
Products manufactured, sold, or imported in the European Union must display the CE Mark.
European Union standards include standards for electrical appliances (Low Voltage Directive), standards for
electrical noise (EMC Directive), and standards for machinery (Machinery Directive).
This product displays the CE Mark in accordance with the Low Voltage Directive, the EMC Directive, and the
Machinery Directive.
Table 5.1 Harmonized Standards
European Directive Harmonized Standard
CE Low Voltage Directive Compliance
2014/35/EU
EN 61800-5-1
EMC Directive
2014/30/EU
EN 61800-3
Machinery Directive
2006/42/EC
• EN ISO 13849-1:2015 (PL e (Cat.III))
• EN 62061 (SILCL3)
• EN 61800-5-2 (SIL3)
Restriction of the use of certain hazardous substances (RoHS)
2011/65/EU
EN IEC 63000
The customer must display the CE Mark on the final device containing this product. Customers must verify that
the final device complies with EU standards.
Table 5.2 Other Applicable Standards
European Directive Applicable Standards
EU ErP Directive
2009/125/EC
YASKAWA CR700 series meets the requirements for IE2 efficiency according to the European regulation 2019/
1781.
The losses and the efficiency class were determined in accordance with EN 61800-9-2
◆
CE Low Voltage Directive Compliance
It has been confirmed that this product complies with the CE Low Voltage Directive by conducting a test
according to EN 61800-5-1.
The following conditions must be satisfied for machines and devices incorporating this product to comply with
the CE Low Voltage Directive.
■
Area of Use
Install this product in a location with Overvoltage Category III and pollution degree 2 or less as specified in IEC/
CE 60664.
■
Guarding Against Debris
When you install IP20/UL Open type drives, use an enclosure that does not let unwanted material enter the drive
from above or below.
■
Wiring Diagram
Refer to Figure 5.2 for an example of a drive that is wired to comply with the CE Low Voltage Directive.