3-1
167646-1CD
HW1481264
3
Function Settings
3.1 Description of Function Setting Switches
Interface Board for Welding
Power Supply
3
Function Settings
3.1
Description of Function Setting Switches
The names of the switches to set the functions of this board and how each
switch works are shown below. Make sure to perform proper settings
according to the following description. For details of the settings, refer to
the next page.
• S1:
Sets the station of this board on the DX200.
The setting range of the station is 1 (ST#01) to D (ST#13).
0, E, or F cannot be set.
• SW1: Sets the transfer rate.
Switches between 4 Mbps and 10 Mbps.
Make sure to set SW1 to 4 Mbps.
10 Mbps cannot be used.
If this board’s information is not displayed on the
programming pendant screen although the communication
cable and power cable are connected correctly according to
section 5.1 “I/O Module Setting” on page 5-1
, SW1 may be
set to 10 Mbps. If so, change it to 4 Mbps.
• SW2: Sets the I/O communication mode.
Switches between 17 BYTE or 32 BYTE.
Make sure to set SW2 to 17 BYTE.
32 BYTE cannot be
used.
If this board’s information is not displayed on the
programming pendant screen although the communication
cable and power cable are connected correctly according to
section 5.1 “I/O Module Setting” on page 5-1
, SW2 may be
set to 32 BYTE. If so, change it to 17 BYTE.
15 of 40
