3-2 Installation of CM086 Board
Installation Procedure
These procedures should be followed when installing the CM086 board into the GPD 506 drive.
1.
Turn the main power OFF to the drive, and wait the specified length of time shown on the front
cover. Remove the front cover of the drive to verify that the CHARGE lamp is off.
2.
Position the CM086 board onto the control board of the drive, lining up the four (4) spacer holes
on the board with the four (4) plastic stand-offs on the drive. Snap the CM086 board onto the
stand-offs tightly.
3.
Plug the connector from the CM086 board into location 2CN on the control board. Be sure to
correctly align the connection locking tab with its mating part on 2CN.
4.
Connect the green wire (labeled ‘E’) from the CM086 board to the ground wire post or ground
terminal (also labeled ‘E’) on the drive.
5.
After installing the CM086 board onto the drive, connect with peripheral devices and replace the
cover of the drive.
Figure 3-1. Position of the CM086 Board on the GPD 506 Drive