YASKAWA GA500 series, Programming

Page: 328 / 526

2.8 H: Terminal Function Selection
328 YASKAWA TOEPYAIGA5002A GA500 Programming
Note:
The terminal deactivates in these conditions:
• During Stop
•
During baseblock
•
During DC Injection Braking (initial excitation)
• During Short Circuit Braking
Figure 2.84 Active Frequency Output Time Chart
■
38: Drive Enabled
Setting Value Function Description
38 Drive Enabled
This terminal activates when the H1-xx = 6A [Drive Enable] terminal activates.
■
39: Watt Hour Pulse Output
Setting Value Function Description
39 Watt Hour Pulse Output
Outputs the pulse that shows the watt hours.
Note:
Refer to “ H2-06: Watt Hour Output Unit Selection ” for more information.
■
3C: LOCAL Control Selected
Setting Value Function Description
3C LOCAL Control Selected
The terminal activates when the Run command source or frequency reference source is LOCAL.
ON : LOCAL
The keypad is the Run command source or the frequency reference source.
OFF : REMOTE
The Run command source or frequency reference source is an external source set with b1-01 [Frequency Reference
Selection 1] , b1-15 [Frequency Reference Selection 2] , b1-02 [Run Command Selection 1] , or b1-16 [Run Command
Selection 2] .
■
3D: During Speed Search
Setting Value Function Description
3D During Speed Search
The terminal activates when the drive is doing speed search.
Note:
Refer to
“
b3: Speed Search
”
for more information.
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV
V/f OLV OLV/PM OLV/PM AOLV/PM EZOLV