3.2 Operating Procedures for Utility Functions
3.2.35 ZONE Table Edit/Save (FnB04)
3-114
3.2.35
ZONE Table Edit/Save (FnB04)
This function edits and saves ZONE tables. Saving a ZONE table to flash
memory after editing it ensures that the data will be retained even after
the control power has been turned off.
Codes Displayed on the ZONE Table Editing
Screen
Refer to the following manual for information on interpreting the dis-
plays.
Σ
-7-Series
Σ
-7S SERVOPACK Command Option Attachable Type with INDEXER
Module Product Manual (Manual No.: SIEP S800001 64)
Preparation
Always check the following before you edit or save a ZONE table.
•
The parameters must not be write-prohibited (Fn010 must be set to
0000).
•
A ZONE table save operation must not be in progress for any means
other than the digital operator.
Editing ZONE Tables
The operating procedure when setting ZONE N in ZONE number 5 is
explained here.
ZONE
Number
ZONE P
ZONE N
0
ZP000
ZN000
1
ZP001
ZN001
…
…
…
31
ZP031
ZN031
Step
Operation
Result
1
Press the
key to open the Utility
Function Mode main menu, and move
the cursor with the
keys to
select FnB04.
2
Press the
key to view the FnB04
operation screen.
Continued on next page.
㹀㹀ࠉࠉࠉࠉࠉ㹄㹓㹌㹁㹒㹇㹍㹌
㹄㹬㹀㸮㸱ࠉ㹎㹅㹋ࠉ㹃㹢㹧㹲
㹄㹬㹀㸮㸲ࠉ㹘㹍㹌㹃ࠉ㹃㹢㹧㹲
㹄㹬㹀㸮㸳ࠉ㹈㹑㹎㹂ࠉ㹃㹢㹧㹲
㹄㹬㹀㸮㸴ࠉ㹎㹅㹋ࠉ㹇㹬㹧㹲
㹀㹀ࠉࠉࠉࠉ㹘㹭㹬㹣㹃㹢㹧㹲
㹘㹎㸮㸮㸮㸻㸩㸮㸮㸮㸮㸮㸮㸮㸮
㹘㹎㸮㸮㸯㸻㸩㸮㸮㸮㸮㸮㸮㸮㸮
㹘㹎㸮㸮㸰㸻㸩㸮㸮㸮㸮㸮㸮㸮㸮
㹘㹎㸮㸮㸱㸻㸩㸮㸮㸮㸮㸮㸮㸮㸮
