2.2 Harmonic Filter Module Installation
YASKAWA ELECTRIC
TOEP C710656 07A YASKAWA Power Regenerative Converter - D1000 Instruction Manual
39
Mec
h
an
ic
al
In
st
al
la
tio
n
2
■
Installation Spacing
shows the installation distance required to maintain sufficient space for airflow and wiring.
Figure 2.10
Figure 2.11 Installation Spacing
■
Precautions and Instructions for Installation of Harmonic Filter Module
Read the following precautions and instructions before installing a harmonic filter module.
WARNING!
Always observe the following precautions. If handled incorrectly, the harmonic filter module may fall, possibly causing
injury. Also, the harmonic filter module may be damaged.
•
Suspend the harmonic filter module with wires only temporarily and only when installing them in a control
panel. Do not suspend them when transporting them.
•
Before you suspend the harmonic filter module, confirm that faceplate, top cover, and other configuration
components are securely screwed in place.
•
Do not place the harmonic filter module on its side.
•
Do not leave the harmonic filter module suspended with wires for a long period of time.
Attach hooks to the specified locations when suspending the harmonic filter module with wires.
NOTICE:
Do not apply excessive force to the top cover when suspending the harmonic filter.
The top cover may be deformed. When lifting the module by hand, always use the holding frames and use two people. Failure to
comply may damage the module.
Refer to
for details.
Figure 2.11
Figure 2.12 Suspension Locations for the Harmonic Filter Module
A – 50 mm minimum
C – 120 mm minimum
B – 30 mm minimum
A – Suspension Holes (Two on Each Side)
B – Holding Frames (One on Each Side)
C
A
B
B
B
A
B
A
A
B
A