YASKAWA CIPR-GA50C series, Technical Manual

Page: 621 / 766

Parameter
Details
12
12.8 H: Terminal Function Selection
YASKAWA SIEPC71061753A GA500 Technical Manual 621
Setting Value Function Reference
66 Comparator1 640
67 Comparator2 640
69 External Power 24V Supply 641
6A Data Logger Error 641
Setting Value Function Reference
90 - 92 DWEZ Digital Output 1 to 3 641
100 - 192
Inverse output of 0 to 92
Sets an inverse output of the function for
the MFDO. Put a 1 at the front of the
function setting to set inverse output. For
example, set
138 for inverse output of 38
[Drive Enabled] .
641
*1 Inverse output is not available.
■
Extend MFDO1 to MFDO3 Function Selection
You can set MFDO functions to bit 0 to bit 2 [MEMOBUS MFDO1 to 3] of MEMOBUS register 15E0 (Hex.).
Use H2-40 to H2-42 [Mbus Reg 15E0h bit0 to bit2 Output Func] to select the function.
Figure 12.73 Functional Block Diagram of MEMOBUS Multi-function Output
Table 12.62 MEMOBUS MFDO Registers
Register No.
(Hex.)
Name
15E0
bit0 MEMOBUS MFDO 1
bit1 MEMOBUS MFDO 2
bit2 MEMOBUS MFDO 3
Note:
•
Refer to H2-xx
“
MFDO Setting Values
”
for more information about MFDO setting values.
• When you do not set functions to H2-40 to H2-42 , set them to F .
■
Output of Logical Operation Results of MFDO
This enables the logical operation results of two MFDOs to be output to one MFDO terminal.
Use H2-60, H2-63, and H2-66 [Term MA,MB,MC Secondary Function, Terminal P1 Secondary Function, and
Terminal P2 Secondary Function] to set the function of the output signal for which you will perform logical
operations.
Use H2-61, H2-64, and H2-67 [Term MA,MB,MC Logical Operation, Terminal P1 Logical Operation, and
Terminal P2 Logical Operation] to set the logical operation.
Figure 12.74 Functional Block Diagram of Logical Operation Output for MFDO 1
Table 12.63 MFDO Logical Operation Table
Logical Operation Selection
Logical Operation Expression Logical Operation Notation
H2-61, H2-64, H2-67
0 A=B=1
1 A=1 or B=1
2 A=0 or B=0
3 A=B=0
4 A=B A=B