YASKAWA CIMR-RA Series, Instruction Manual

Page: 63 / 209

4.2 Using the Digital Operator
YASKAWA ELECTRIC TOEP C710656 10B YASKAWA Power Regenerative Unit - R1000 Instruction Manual 63
St
a
rt
-Up
Pr
ogr
amming
& Op
er
at
io
n
4
4.2 Using the Digital Operator
Use the digital operator to enter Run and Stop commands, edit parameters, and display data including fault and alarm
information.
◆
Keys and Displays
ê} 1
Figure 4.1 Keys and Displays on the Digital Operator
No. Display Name Function
1
<1> The STOP key has highest priority. Pressing the key will always cause the regenerative unit to stop operation, even if a Run command
is active at any external Run command source. To disable the key priority, set parameter o2-02 to 0.
<2> The LO/RE key can only switch between LOCAL and REMOTE when the regenerative unit is stopped. To disable the key to prohibit
switching between LOCAL and REMOTE, set parameter o2-01 to 0.
ESC Key
• Returns to the previous display.
• Moves the cursor one space to the left.
• Pressing and holding this button will return to the DC bus voltage feedback reference display.
2 RESET Key
• Moves the cursor to the right.
• Resets the regenerative unit to clear a fault situation.
3 RUN Key Starts the regenerative unit in LOCAL mode.
4 Up Arrow Key Scrolls up to display the next item, selects parameter numbers, and increments setting values.
5 Down Arrow Key Scrolls down to display the previous item, selects parameter numbers, and decrements setting values.
6 STOP Key
<1>
Stops regenerative unit operation.
7 ENTER Key
• Enters parameter values and settings.
• Selects a menu item to move between displays.
8
LO/RE Selection
Key
<2>
Switches regenerative unit control between the operator (LOCAL) and an external source (REMOTE)
for the Run command and frequency reference.
9 RUN Light Lit while the regenerative unit is operating. Refer to page 64 for details.
10
LO/RE Light
Lit while the operator is selected to run the regenerative unit (LOCAL mode).
11 ALM LED Light
Refer to Table 4.2 for details.
12 FOUT LED Light
13 DRV LED Light
14 REV LED Light
ALM
REV DRV FOUT
LO
RE
ESC
RUN STOP
ENTER RESET
DIGITAL OPERATOR JVOP-182
1
2
3 4 5 6
9
14 13 12
10
8
11
7
RE
LO
RUN
STOP
RE
LO
TOEP_C710656_10B_1_0.book 63 ページ ２０１５年１月８日 木曜日 午後８時５５分