4.5 Digital Operator Modes
40
YASKAWA ELECTRIC
TOEP C710656 01C YASKAWA - RC5 Instruction Manual
◆
Navigating Digital Operator Modes
Once the power regenerative unit has been put into operation mode by pressing the Menu Key, the Increment and Decrement Keys can be pressed to
switch to other modes. Press the DATA/ENTER Key to read/set the user parameters in each mode.
Press the ESC Key to return to the mode display from the user parameter display.
Press the DATA/ENTER Key twice to write a parameter and then press the ESC Key to return to the mode display. This is the most Basic operation,
so you should remember it.
Figure 4.3
Figure 4.3 Mode Transitions
Note:
When running the power regenerative unit after using the digital operator, press the MENU Key to enter the operation mode and then press the DATA/ENTER Key from
the operation mode display to bring up the monitor display. Run commands can’t be received from any other display. (Monitor display in the operation mode appears
when the power is turned ON.)
All modes / parameter
status
** Main Menu **
Operation
** Main Menu **
Initialize
** Main Menu **
Programming
** Main Menu **
Modified Parameters
Power ON
Dc Bus Voltage
U1-02 = 300 VDC
Select Language
English
Group b
Application
None Modified
MENU
ESC
DATA
ENTER
ESC
DATA
ENTER
ESC
DATA
ENTER
ESC
DATA
ENTER
A1-00 = 0***
English
Function b1
Sequence
ESC
DATA
ENTER
ESC
DATA
ENTER
Operation mode
Initialize mode
Programming mode
Modified parameter mode
(Mode Display)
Monitor (DC bus voltage)
Operator display language selection
Operation mode selection
Displays parameterss changed from
factory settings
Function
(Parameter Reading)
Parameter Display
(Parameter Setting)