YASKAWA CIMR-MC5A2011, Instruction Manual, Page: 148 / 294

Advanced Operation
- 10
7.2 Flux Vector Control
The functions that can be used with flux vector control are listed in Table 7.2. Details on functions that are spe-
cific to flux vector control (i.e. those marked with a ) are provided in the following table.
Table
7.2 Flux Vector Control Functions
Group Function Comments
Control Meth-
od
Group Function Comments
Open
Loop
Vector
Flux
Vector
b1 Sequence Settings such as the reference input method
b Application b2 DC Injection Braking DC injection braking function settings b Application
b3 Speed Search Speed search function settings
C1 Accel/Decel Acceleration/deceleration time settings
C2 S-Curve Acc/Dec S-curve characteristics for accel/decel times
C3 Motor-Slip Compensation Motor temperature compensation function adjustment
C Tuning
C4 Torque Compensation Not used. (Can’t be set.)
C Tuning
C5 Speed Controls Speed control loop adjustment
C6 Carrier Frequency Carrier frequency settings
C8 Factory Tuning
Not used. (Can’t be set.)
d1 Preset Reference Frequency reference settings (when using Operator)
d2 Reference Limits Frequency upper and lower limit settings
d Reference
d3 Jump Frequencies
Prohibited frequency settings
d4
Reference frequency hold
function
Up/Down, Accel/Decel stop hold frequency setting
E1 V/f Pattern
Motor constant settings
E2 Motor Setup
Motor constant settings
(Motor constants set automatically with autotuning.)
E Motor E3 Motor 2 Control Methods Control method settings for motor 2. E Motor
E4 Motor 2 V/f Characteristics
V/f characteristics settings for motor 2.
E5 Motor 2 Motor Constants Motor constant settings for motor 2.
F1
PG Speed Control Card
Settings
Constant settings for a PG Speed Control Card
F2 Analog Reference Card AI User constant settings for an Analog Reference Card
F3 Digital Reference Card DI User constant settings for a Digital Reference Card
F4 Analog Monitor Card AO
User constant settings for an Analog Monitor Card
F Options
F5 Digital Output Card DO User constant settings for a Digital Output Card
F Options
F6 Digital Output Card DO User constant settings for a Digital Output Card
F7 Pulse Monitor Card PO User constant settings for a Pulse Monitor Card
F8
SI-F/SI-G Transmission
Card
User constant settings for a Transmission Card
F9
CP-916B Transmission
Card
User constant settings for a Transmission Card
H1 Multi-function Inputs Function selection for multi-function inputs
H2 Multi-function Outputs Function selection for multi-function outputs
H T i l
H3 Analog Inputs
Function selection for analog inputs
H Terminal
H4
Multi-function Analog Out-
puts
Function selection for analog outputs
H5
MEMOBUS Communica-
tions
MEMOBUS communications settings
L1 Motor Overload Sets electrical/thermal functions that protect the motor.
L2 Power Loss Ridethru Selects the power-loss processing method.
L3 Stall Prevention Accel/Decel stall prevention settings and selection
L Protection
L4 Reference Detection Frequency detection settings and selection
L Protection
L5 Fault Restart Fault restart function settings
L6 Torque Detection
Sets overtorque detection functions 1 and 2 (by current)
L7 Torque Limit Torque limit function settings
L8 Hardware Protection Hardware overheating and open-phase protection settings
o Operator
o1 Monitor Select
Selects the Operator’s display and setting methods.
o Operator
o2 Key Selections Operator’s key function selection and other constants
7