YASKAWA CC-Link SI-C3, Installation Manual

Page: 38 / 139

7 Basic Functions
38 YASKAWA TOEP C730600 83A CC-Link Installation Manual
No.
(Hex.)
Name Description
Default
(Range)
B : number of remote device nodes (42 max)
C : number of local nodes (26 max)
F6-11
(03B7)
CC-Link
Communication
Speed
(For Drive,
D1000)
Sets the communication speed for CC-Link communication.
Change the parameter then cycle power on the drive.
0 : 156 kbps
1 : 625 kbps
2 : 2.5 Mbps
3 : 5 Mbps
4 : 10 Mbps
0
(0 - 4)
F6-14
(03BB)
BUS Error Auto
Reset
(For Drive,
D1000)
Sets the automatic reset function for bUS [Option
Communication Errors] .
0 : Disabled
1 : Enabled
0
(0, 1)
7 Basic Functions
This product is a communication interface to operate, adjust, and monitor the drive as CC-
Link remote station with a PLC program. You can use cycle transmission of bit data and
word data, which enables high-speed communication at up to 10 Mbps.
This section explains the basic functions to operate using a PLC by CC-Link
communication function.
Note:
First, set the parameters to operate the drive using a PLC . Refer to Related Drive Parameters on page 34 for
more information.
◆
Monitor
You can monitor operation status of the drive from a PLC.
Follow the following directions to monitor.
1.
Set the monitor code to remote register RW
W0
.
2.
Switch ON the RYC signal (request to execute the monitor code).
The data according to Monitor Code is stored in the buffer memory of the PLC.
Note:
For a list of monitor codes, write data drives, and setting ranges, refer to the instruction manual for the
drive the CC-Link Option is connected to.