5 Installation Procedure
24
YASKAWA ELECTRIC
TOBP C730600 79C YASKAWA AC Drive Option AO-A3 Installation Manual
3.
Insert the option card (B) into the CN5-A (G), CN5-B (H) and CN5-C (I) connector
on the drive and fasten it into place using the included screws (C). Tighten both
screws to 0.5 to 0.6 N
m (4.4 to 5.3 in. lbs).
Figure 13
Figure 13 Insert the Option Card
Note:
Installing the option card on a GA700, CR700, and CH700 drive requires only two screws and
does not require a ground wire. The option package ships with three screws and ground wires for
installation on other product series. Do not use the ground wire or the extra screw.
4.
Prepare the wire ends as shown in
Figure 14
Figure 14 Prepare Ends of Shielded Cable
C
I
H
G
B
A
AO
Insulation
Shield sheath
Option terminal
To customer
circuit
FE
(Insulate with electrical tape
or heat-shrink tubing)
AO
GEM_IO_conditional_E_AO.fm 24 ページ ２０１７年７月５日 水曜日 午後５時３３分
