n
Set Ethernet Parameters
The dialog field for pre-setting an Ethernet address can be found in
‘Start
è
Settings
è
Network and Dial-up Connections’
. The default setting is address assignment via
DHCP.
n
System Properties (System)
Via
‘Start
è
Settings
è
Control Panel
è
System’
you receive information about the
version of the current Windows
Ò
operating system, the memory load and sharing
(alterations here are not accepted into the registry) and the copyright. The register
‘Device Name’
allows you to change the device name that is shown during Ethernet
communication for instance.
Please note that changes made are set back after PowerOFF-PowerON
and are only stored via ‘Start
è
Programs
è
KuK_Tools
è
KuK Tools’
[Store].
The dialog window where to configure the integrated MPI interface can be found under
‘Start
è
Settings
è
Control Panel
è
MPI Configuration’
.
n
HSA
Here you set the highest MPI address (highest station address). Within a MPI network
the highest MPI address must be identical!
n
TS
With TS (this station) you set the local MPI address for the Touch Panel.
n
Baud Rate
Enter here the transfer velocity of your MPI net. The baud rate has to be identical for
every MPI participant within the network. According to the Baud Rate the network
parameters are set.
n
Default Net Parameters
It is recommended not to alter the Default Net Parameters that are set by the baud
rate.
n
Status
The status of the MPI interface is monitored via Status as "Offline", "Online" or
"Error".
Here made changes are also not saved after PowerOFF-PowerON. Save
the data permanently in the current registry file via [Store] under ‘Start
è
Programs
è
KuK_Tools
è
KuK Tools’.
Set MPI parameters
HMI
Deployment Touch Panel
Operating system Windows Embedded Compact 7 > Structure
HB160 | TP | 62K-JJK0 | en | 22-04
36
