Precautions that involve your safety.
CAUTION!
Read the instruction manual and follow the warning and safety instructions!
CAUTION!
Always wear eye protection.
Do not use in rain or electrical storms.
WARNING!
The cutting blades continue to move after switching off.
WARNING!
Keep bystanders away.
Only use the battery charger indoors.
Battery charger contains a safety transformer.
Waste electrical products should not be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority or retailer for recycling advice.
EXPLANATION OF SYMBOLS
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
3
Model LSS10163
-
1
CHARGING THE BATTERY
•
The battery must be fully charged before using
for the first time. The charging time is 3 to 5
hours. (See page 5 for instructions.)
•
The battery charger supplied matches the
lithium battery installed in the tool. DO NOT
use any other charger to recharge the tool.
•
To protect the lithium battery against deep
discharging, when the battery is flat, the tool
will automatically switch off via a protective
circuit.
If the On/Off switch is used continually at this point,
the lithium battery can be damaged. Do not try to
continue to use the tool before recharging the
battery.
GENERAL SAFETY
FCC Warnings:
Please note that changes or modifications to this
product not expressly approved by the party
responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the
following measures:
--
Reorient or relocate the receiving antenna.
--
Increase the separation between the equipment and
receiver.
--
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
--
Consult the dealer or an experienced
radio/TV
technician for help.