model no. 060-3891-6 | contact us: 1.866.523.5218
6
Assembly
Wear goggles.
Wear hearing protection.
Wear a breathing mask.
!
Note:
Attempting to restart the tool in this condition, without
either recharging the battery or installing a charged battery, will
lead to the blower restarting and then stopping again after only
a few seconds of operation. These safety devices have been
fitted for the safety, reliability and life of the tool.
UNPACKING
Due to modern mass production
techniques, it is unlikely that your Automatic
Power Tool is faulty or that a part is missing.
If you find anything wrong, do not operate
the tool until the parts have been replaced
or the fault has been rectified. Failure to do
so could result in serious personal injury.
IMPORTANT INFORMATION – PRODUCT
CARE
This blower uses Lithium Ion Battery Cells.
Care MUST be taken to ensure both the
safety and life of the pack is maintained.
Ensure you have read all of the safety notes
in the following pages before using the
blower. Safety devices and circuitry for this
tool are located in the battery pack of this
tool. The battery pack is a vital component,
not just for the power source, but also for
the full safety control for both charging and
operating the tool. Treat the battery pack
with care, following the guidelines in this
manual. If the pack becomes immersed
in water or any fluids, or is dropped from
a significant height, etc., or it does not
operate as outlined in the guidelines of
this manual, immediately STOP using the
battery pack and have it checked.
ACCESSORIES
1 x 18 V Lithium-ion Battery
Battery Charger
As mentioned previously, the battery pack
is an integral component of this tool and
it is fitted with thermal safety devices.
Running the blower at close to maximum
load, or continual resetting of the overload,
will cause the battery pack to over heat.
When a preset cell temperature is detected,
the battery pack will automatically STOP
operating and will not restart until the
battery pack has cooled to a safe level.
In this condition, DO NOT force cool the
pack by placing in a freezer or similar
device. Refer to the “Overload” section in
this manual.
Another feature of the blower/battery pack
is the low voltage cut out feature. This
feature operates when the voltage drops
below a pre-set value. When this occurs,
the tool will automatically stop operating.
To correct the situation you need to either
insert another charged battery into the
blower or recharge the existing battery, and
then proceed with using the blower.
