model no. 060-3808-8 | contact us: 1-866-523-5218
9
When using a power tool at a considerable distance from a power source, be sure to use an
extension cord that has the capacity to handle the current the product will draw. An
undersized cord will cause a drop in line voltage, resulting in overheating and loss of power.
Use the chart to determine the minimum wire size required in an extension cord. Only round
jacketed cords listed by Underwriter’s Laboratories (UL) should be used.
When working outdoors with a product , use an extension cord that is designed for outside
use. This type of cord is designated with “W-A” or “W” on the cord’s jacket. Before using any
extension cord, inspect it for loose or exposed wires and cut or worn insulation.
•
Make a knot as shown in Figure on page 10, or
•
Electrical Information
Use one of the plug-receptacle retaining straps or connectors described in this manual.
EXTENSION CORDS
Minimum Gauge for Extension Cords (AWG)
(when using 120 V only)
Ampere Rating
Total Length of Cord in Feet (meters)
More Than Not More Than 25' (7.6 m)
50' (15 m)
100' (30.4 m) 150' (45.7 m)
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
Not Recommended
Extension Cord – Make sure your extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to carry the current your product will draw.
An undersized extension cord will cause a drop in line voltage resulting in loss of power and
overheating. The table shows the correct size to use depending on cord length and
nameplate ampere rating. If in doubt, use the next heavier gage. The smaller the gage
number, the heavier the cord. To reduce the risk of disconnection of appliance cord from the
extension cord during operating:
