model no. 060-2341-2 | contact us: 1.866.523.5218
16
Operation
5. TO REMOVE THE CAP (SEE FIG. M1,M2)
Press and hold in the two latches (a, b). (See Fig. M1) Pull cap away from the spool holder (See
Fig. M2) when refitting the spool cap. Keep all areas of the cap and spool holder clean. Replace
the cap, pressing firmly down towards the spool holder to ensure cap is fully located. Check that
the cap is correctly fitted by trying to remove it without depressing the two latches.
6. TO REPLACE CUT LINE
For your convenience it is recommended you buy spool and line complete.
4. TO MANUALLY FEED THE LINE (SEE FIG. L)
If required, line can be fed out manually. Before manually feeding, remove the battery first. To
operate, press and release manual line feed button (a), while gently pulling out the lines until
the lines reach the line cutter. If the line extends past the line cutter, too much line has been fed
out. If too much line is fed out, remove the spool cap and turn spool counter-clockwise until the
line is at the desired length.
a
b
a
L
M1
M2
