model no. 054-5756-6 | contact us: 1.866.523.5218
model no. 054-5756-6 | contact us: 1.866.523.5218
35
MAINTENANCE
QUICK REFERENCE OF CHAIN&BAR ASSEMBLY (KNOB TENSION)
1, To remove the side cover,
loosen the locking knob one
full turn counterclockwise.
4, The bar and chain can now
be removed by lifting it away
from the main body of the
saw and releasing the chain
from the drive pulley.
5, The chainsaw can now be
cleaned with a brush or a rag
to remove sawdust and oil
7, Ensure that the adjusting
b l o c k i s l o c a t e d i n t h e
tensioning hole on the chain
bar.
10, Turn the tension knob
clockwise to tighten the chain.
11, Until there is enough play
that the chain can be pulled
away from the bar, but not so
much that the runners can be
pulled out of the bar.
8, And that the rubber block
and chain bar are free from
oil, as this helps to keep
tension on the chain.
9, Replace the side cover
and locking knob, but do not
tighten.
1 2 , O n c e y o u h a v e t h e
correct tension, fully tighten
the locking knob.
6, To replace the bar and
chain, loop the chain over the
drive pulley and place the bar
against the centre alignment
groove.
2, Then loosen the chain
tension knob 2 or 3 turns.
3, Now totally remove the
locking knob and remove the
side cover.
ADJUSTING
BLOCK
NOTE: 1) Chains stretch with use, check and adjust tension often.
2) Never tension a warm chain before storing, as chains shrink when cool, this can damage chain , bar
and saw.
