model no. 054-5745-0 | contact us: 1.866.523.5218
16
Oper
ation
APPLICATIONS
you can use this product for the purposes listed below:
•
Basic limbing, felling, and woodcutting.
•
Removing buttress roots.
ADDING BAR AND CHAIN LUBRICANT (See Fig. 6)
use a lubricant that is designed for chains and chain oilers, and is formulated to perform over a
wide temperature range with no dilution required.
NOTE:
The chainsaw comes from the factory with no bar and chain oil added. Level should also
be checked after every 20 minutes of use and refilled as needed.
•
Remove oil cap.
•
Carefully pour the bar and chain oil into the tank.
•
wipe off excess oil.
•
Check and fill the oil tank when quick-view oil indicator is below the MIN. line.
•
Repeat as needed.
NOTE:
Do not use dirty, used or otherwise contaminated oils. Damage may occur to the bar or
chain.
NOTE:
It is normal for oil to seep from the saw when not in use. To prevent seepage, empty the
oil tank after each use, then run for one minute. when storing the unit for a long period of time
(three months or longer), be sure the chain is lightly lubricated. This will prevent rust on the chain
and bar sprocket.
!
WARNING: Do not allow familiarity with products to make
you careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
!
WARNING: Always wear safety goggles or safety glasses
with side shields that comply with ANSI Z87.1 when
operating power tools. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
!
WARNING: Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended can
result in serious personal injury.
