1. The front hole of the swing arm is fixed to the short shaft on
the side of the left leg with bushing, washer and cotter pin. and
the rear hole of the swing arm is fixed on the short shaft on
the inside of the bending plate. The inner side is fixed with a
bushing, a washer and a cotter pin. (See
Figure 9
)
1. Loosen the lock nut, adjust the table angle adjustment bolt
backward to increase the length of the ejector rod, and the
table tilts upward; On the contrary, adjust the table angle
adjustment bolt forward to shorten the length of the ejector
rod, and the table will tilt down. When the height of the table
and beam is aligned, lock the nut tightly. (See
Figure 10
)
25 X 20 X 8
X 2
7
φ
20
X 2
5 X 35
X 2
Figure 9
Swing Arm
Bushing 25 X 20 X 8
(x2)
Washer
φ
20
(x2)
Pin5 X 35
(x2)
Swing Arm
Swing Arm
Bushing 25 X 20 X 8
(x2)
Washer
φ
20
(x2)
Pin5 X 35
(x2)
Swing Arm
Log Lift Table Attachment height Adjustment
Swing Arm Assembly
Figure 10
(x1)
LockNut M10
(x1)
Table Angle Adjustment Bolt M10x40
(x1)
LockNut M10
16
mm
13
mm
10
mm
18
mm
19
mm
24
mm
32
mm
8
Log lift table attachment
»
Operator’s Manual
Assembly
|
