GEAR SELECTION LEVER
The gear selection lever has 4 positions: 3 forward
speeds and 1 reverse. To change speeds, move the
speed shift lever to the desired position. The lever
locks in a notch at each speed selection.
Slower speeds are for heavier loads, while faster
speeds are for transporting light loads or an empty
hopper. It is recommended that you use a slower
speed until you are familiar with the operation of the
power trackbarrow.
If the engine slows down under a load or the tracks
slip, shift the machine into a lower gear.
If the front of the machine rides up, shift the machine
into a lower gear. If the front continues to ride up, lift
up on the handles.
Always release the clutch control lever before changing
speeds. Failure to do so will result in damage to the
power trackbarrow.
Operate the lever to turn left/right.
To raise the hopper, pull the tipping handle upwards
(see
Figure 4, Illustration a
) until the hopper has
reached the desired position. To stop raising the
hopper, simply release the tipping handle and the
tipping handle will return to its original position.
To lower the hopper, pull the tipping handle down (see
Figure 4
,
Illustration b
) with the right hand. When the
hopper is lowered to the original position, release the
tipping handle back to its original position.
LEFT/RIGHT STEERING LEVER
HYDRAULIC TIPPING HANDLE
Operate the steering levers only at a reduced speed.
Figure 3
Figure 4
ENGINE ON/OFF SWITCH
The engine switch has two positions. OFF - engine will
not start or run. On - engine will start and run.
RECOIL STARTER HANDLE
The Recoil Starter Handle is used to start the engine.
FUEL SHUT-OFF VALVE
The fuel shut – off has two position.
CLOSED
(
) - use this position to service, transport,
or store the unit.
OPEN
(
) - use this position to run the unit.
Hydraulic Tipping Handle
B
A
Illustration a
Illustration b
12
Power Trackbarrow
»
Operator’s Manual
YD8105PM04 - 1804
Know Your Machine
|
