Page 3 of 7
ASSEMBLY INSTRUCTIONS
NOTE:
Do not completely tighten screws until the assembly is complete. For easier assembly, we recommend
two people to assemble this product.
STEP 1: Install Front Axle Support, Front Wheels and Handle (See Fig. 2)
Take out the cardboard from the shipping carton, put the cart Bed (part# 1) onto it to keep from scratching or
surface damage.
(1) Turn the cart Bed (Part# 1) upside down, so that the exposed screw holes can be seen.
(2) Turn up the foldable Front Axle Support (Part# 3) to line up holes on the Bed (part# 1) and lock it with Hex
Nut (Part# 15) and washer (Part# 12).
(3) Assemble the Steering Link Connector (Part# 20) on the Front Axle Support (Part# 3) with Nut (Part# 15),
bolt (Part# 10) and washer (Part# 12) Don't need to fasten tightly.
(4) Slide the Wheel (Part# 7) into the Axle with the valve steam facing out. Using Washer (Part# 14) (Part# 21)
and Convex Nut (Part# 17) to fasten the Wheel (Part# 7).
(5) Place the Yoke (Part# 5) to the Front Axle Support (Part# 3). Put short side of the Yoke (Part# 5) onto the
center stud of the Front Axle Support (Part# 3) use one Lock Pin (Part# 9) and Washer (Part# 13) to fasten it.
Put long side of the Yoke (Part# 5) to the Front Axle Support (Part# 3) and Steering Link Connector with Bolt
(Part# 10) and Nut (Part# 15).
(6) Assemble Center Front Axle Brace (Part# 18) on Bed (Part# 1) and Front Axle Support (Part# 3) with Nut
(Part# 15) and Washer (Part# 12) then fasten.
(7) Put the Handle (Part# 6) and Plastic Coupling (part# 19) to the Yoke (Part# 5) using Bolt (Part# 11),
Washer (Part# 12) and Nut (Part# 15).
