![background image](http://html1.mh-extra.com/html/yard-machines/mct333601/mct333601_operators-manual_906045013.webp)
13
MAINTENANCE AND REPAIR INSTRUCTIONS
Fig. 26
Fig. 25
Fig. 24
6. Insert each end into locking tabs by pushing the line
end through lower tab hole and looping end back
through upper tab hole. Pull line at eyelet to tension
(Fig. 24).
7. Once both line ends are locked in place turn inner
spool counter clockwise in direction of arrows to
load line (Fig. 25).
8. Wind spool until a loop of line approximately 10
inches (25cm) long is visible. Cut loop in half to
create two cutting line ends (Fig. 26). Ensure each
line end is not more than 5 inches (13cm) long. This
will minimize load on engine during starting.
AIR FILTER
To clean the air filter:
1. Remove the 2 screws holding air filter cover in place
(Fig. 27).
2. Remove the cover and lift the filter from the air box
(Fig. 28).
3. Wash the air filter in soap and water. DO NOT USE
GASOLINE!
4. Air dry filter.
5. Reinstall the filter, cover and screws.
NOTE: Replace filter if frayed, torn, damaged or unable
to be cleaned.
Never operate the
unit without the air
filter. The air filter must be kept clean. If it
becomes damaged, install a new filter
CAUTION:
Fig. 27
Fig. 28
Screws
Cover
Air Filter