10
Service
a) Have your power tool serviced by a
qualified repair person using only identical
replacement parts. This will ensure that the
safety of the power tool is maintained.
CORDLESS GRASS TRIMMER SAFETY
WARNINGS
1. Read the instructions carefully
2. Be familiar with the controls and proper use
of the equipment
3. Wear protective glassed or goggles
4. Never allow children or people unfamiliar with
the instructions to use the machine .
5. Stop using the machine while people.
Especially children or pets are nearby
6. Only use the machine in daylight or good
artificial light.Never use when visibility is bad.
7. Before using the machine and after any
impact . check for the sings of wear or
damage and repair as necessary
8. Never operate the machine with damaged
guards or without the guards in place.
9. Keep hands and feet away from the cutting
means at all times and especially when
switching on the motor.
10. Take care against injury from any device
fitted for trimming the filament line length.
After extending new cutter line always return
the machine to its normal operating position
before switching on
11. Never fit metal cutting elements. Only use
2.3mm rounded nylon line.
12. Never use replacement parts or accessories
not provided or recommended by the
manufacturer.
13. Ensure that the battery pack has been
removed before checking , cleaning or
working on the machine and when it is not in
use.
14. Always ensure that ventilation openings are
kept clear of debris.
15. During assembly take great care when fitting
the guard as this has a very sharp cutting
edge on one side for cutting the nylon line.
16. Never hold the cutter head above foot height
or point it towards people or animals when in
use.
17. If the trimmer starts to vibrate excessively
switch off immediately and have it checked
by a qualified service engineer.
CAUTION:
The cutting head continues to
rotate for a few seconds after switching off.
18. Always remove any sticks and stones etc.
before using the trimmer.
19. Do not cross roads or gravel paths while
operating trimmer.
20. On steep slopes cut across the slope, never
in an up and down direction. Never run while
using the trimmer.
21. Never use the trimmer while it is raining or in
damp weather.
22. Do not overreach, keep proper footing and
balance at all times.
23. Use only genuine spare parts. Only these
spare parts are designed and suitable for
the product. The use of other spare parts not
only voids the warranty, but also endanger
yourself and your environment.
24. Never use of appliance for edging operation.
Special Operation safety for the charger
1. Recharge only with the charger specified by
the manufacturer. Do not use the original
charger on other li-ion batteries or on any
other type of battery—fire or explosion may
occur.
2. Check the battery charger, cable and plug
each time before using. Do not use the
battery charger when defects are detected.
Do not open the battery charger yourself and
have it repaired only by qualified personnel
using original spare parts.
3. The charger is designed to use standard
household 100~240 V, 50/60 Hz power
source. The charger’s plug must match the
outlet. Never modify the plug in any way.
Unmodified plugs and matching outlets will
reduce risk of electric shock.
4. Do not abuse the cord of charger. Never use
the cord for carrying, pulling or unplugging
the charger. Keep cord away from heat, oil,
sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric
shock.
5. Make sure the charger cord is located so
that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
6. Keep the battery charger clean.
Contamination may cause the danger of
electric shock.
7. Protect the battery charger from rain and
moisture. The penetration of water in a
battery charger increases the risk of electric
shock.
8. Do not operate the battery charger on easily
inflammable surfaces (e.g. paper, textiles,
etc.) or in combustible environments. There
is danger of fire due to the heating of the
battery charger during charging.
