10
pockets or bags, as they could short-circuit
against other metal items.
7. If an exposed li-ion battery pack dose start a
fire, it wll burn even more violently if it comes
into contact with water or even the moisture
in the air.
DO NOT throw water on a burning
li-ion battery! A fire extinguisher must be
used.
8. If the battery pack becomes too hot to the
touch during charging, disconnect and switch
off immediately. Contact Service Centre
directly.
9. Do not open the battery yourself. There is
danger of a short circuit.
10. When battery pack is not in use, keep it away
from other metal objects, lie paperclips,
coins, keys, nails, screws or other small
metal objects, that can make a connection
from one terminal to another. Shorting the
battery terminals together may cause burns
or a fire.
ASSEMBLY
Assembling the lower tube to upper tube
(See Fig. 3)
WARNING:
Before performing any
assembly. Always ensure that the battery pack
has been removed.
1. Select the lower tube nozzle type – round or
flat.
- Round nozzle for general blowing.
- Flat nozzle for concentrated blowing
2. Aligning the slot on the lower nozzle you
chosen with raised post on the upper tube.
3. Push them against each other.
4. Twist the lower nozzle clockwise.
5. Make sure that the nozzle is securely fitted
with upper tube.
OPERATION
Inserting and removing the battery pack
To insert the battery pack
1. Align the groove on the battery pack with the
corresponding mounting ribs and press the
battery pack down until you hear a “click”.
2. Check to make sure the battery pack is firmly
secured into position- and make sure the
handle is closed on top of battery.
Battery Pack Y0L120BAT2.5 (See Fig. 9)
1. Lift handle
2. Main housing
3. Indicator button
4. Green LED lamps
5. Red LED lamp
Battery Pack Operation (See Fig. 10)
1. When you push the power indicator button, the
green LED lights will show the power remaining.
(See Fig. 10
①
)
2. When the battery pack over discharges or remains
very low power, the red LED light will flash. (See
Fig. 10
②
)
3. When the battery pack temperature is exceeded,
the red LED light will flash. Cool it down for 10~20
minutes. (See Fig. 10
②
)
4. When there is fault with the battery pack, the red
LED light will flash. (See Fig. 10
②
)
5. Once the battery pack is correctly located in the
charger, the 4 green LED lights of the battery
pack will flash LED lights to indicate the charging
process. At the same time the green LED light of
the charger will flash continuously during normal
charging, while the red LED light is still on. (See
Fig. 10
③
)
To remove the battery pack from the tool (See
Fig. 4)
1. Depress the releasing/locking button on the
housing.
2. The battery pack will pop up automatically.
Then lift/rotate the battery handle and remove
the battery .