9
NOTICE:
ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the garden hose to the high
pressure hose (C), spray gun (D), and spray wand (E).
Lubricate all connections shown above, following these
instructions:
1) Inspect and clean connecting surfaces prior to lubrication
and assembly.
all that is required.
3) Use a small brush or cotton swab to apply grease directly
6.Connect
7.Connect High Pressure Hose to Pump
Water Supply to Pump
IMPORTANT! DO NOT
run the pump without the water
supply connected and turned on.
• Damage to pressure washer resulting from failure to follow
this instruction will void warranty.
NOTICE:
NOTICE:
Remove and discard the shipping caps from the
pump’s high pressure outlet and water inlet before attaching
hoses.
Before you connect your garden hose to the water inlet,
inspect the inlet screen. Clean the screen if it contains
debris or have it replaced if damaged. Do Not run
the pressure washer if the inlet screen is damaged or
missing.
IMPORTANT!
NEVER siphon standing water for the water
supply. Use only cold water (less than 100 °F).
CAUTION!
Using a One Way Valve (vacuum breaker
or check valve) at pump inlet could cause pump or inlet
connector damage.
1) There must be at least 10 ft. (3 m) of unrestricted garden
hose between pressure washer inlet and any device,
such as a vacuum breaker or check valve.
2) Damage to pressure washer resulting from failure to
follow this instruction will void warranty.
4) Connect garden hose (not to exceed 50 ft. in length) to
water inlet. Tighten by hand.
Water supply must flow at least 3.7 GPM or more.
D
E
C
WARNING!
The high pressure stream of water that the
Take out the high pressure hose from the hose holder, uncoil
high pressure hose and attach one end of hose to high pressure
oulet on pump. Tighten by hand.
pressure washer produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
• NEVER connect high pressure hose to spray wand.
• Keep high pressure hose connected to pump and spray
gun while system is pressurized.
• Always be certain spray gun, wand, nozzles and other
accessories are correctly attached.
