22
23
OPERATION
Charging the battery pack
NOTE:
Remove the battery pack from the charger after it has been fully charged.
NOTE:
Battery should be fully charged before first use.
NOTE:
Make sure the mains voltage is the same as rating label which is located on the
charger.
1. Connect the charger to a power supply. Red LED will light up.
2. To insert the battery pack into the charger, align the raised ribs of the battery pack with
the grooves of the charger then push it in.
(Fig. J)
3. The red LED light of the charger will light up and then the green light flashes during
normal charging.
4. After charging is complete, the charger light will turn to a solid green light.
5. Once the battery is fully charged , depress the battery release button and then remove
the battery pack.
Power indicator (See Fig. K)
This Li-Ion battery pack is equipped with a power indicator which is used to show the battery
pack’s remaining charge. Press the power indicator button to check battery charge as picture
showed. The indicator will stay lit for approximately 4 seconds.
To obtain the best life from the battery
1. Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down
or the tool no longer performs a task it previously performed.
2. Avoid conducting short charges. Make sure that the battery is fully charged each time by
allowing the charger to complete its full charging cycle.
3. Avoid allowing loose items like screws or nails etc. to be stored with battery packs as
these or similar items can short battery packs and cause a fire or explosion.
4. Always unplug the charger when not in use and store in a dry and secure place.
5. Avoid charging or storing your battery in temperatures below 5°C and above 45°C.
6. After use, allow the battery pack to cool down for approximately 30 minutes before
attempting to recharge.
Setting cutting height (Fig. L)
1. Adjust the cutting height according to the needs of your lawn.
2. When mowing high grass, start with the maximum cutting height and make a second cut
with a lower cutting height.
WARNING:
Before cutting you lawn, set the cutting height, always ensure that the battery
pack has been removed.
OPERATION
Removing and inserting the battery pack
Insert the battery pack. (Fig. M)
Align the battery pack with its compartment of the tool. Push the battery pack into position
until you hear a click. This means the battery pack has been locked in position, then close the
battery pack cover.
Removing the battery pack from the tool (Fig. N)
Open the battery pack cover. release button and then remove the battery pack.
NOTE: Safety-Key (Fig. O)
This lawnmower is fitted with a safety key; this prevents the accidental start up of your
cordless lawnmower.
The safety key has been designed to totally disable the lawnmower when it is removed.
Switching on and off (Fig. P)
Switch on:
1. Press and hold the safety button on the side of the switch box with one hand.
2. Pull the switch lever towards the handle and hold it with the other hand.
Switch off:
Release the switch lever.
NOTE:
Do not continue to press the start button after an automatic shut-off of the machine,
this will lead to battery damage.
WARNING:
When the motor has been switched off, the blade will continue to run for several seconds. Do
not touch the underside of the mower until the cutter has come to a complete standstill!
Operating the lawnmower
NOTE
:
Do not start the lawnmower in the thick Grass--alway start in lower height grass
Operation on a slope:
Slopes increase the risk of slip-and-fall accidents, which can result in severe injury. Always be
sure of your footing on slopes. Operation on slopes requires extra caution. If you feel uneasy
on a slope, do not mow it.
Do:
- Mow across the face of slopes, never mow up and down. Exercise extreme caution when
changing direction on slopes.
- Watch for holes, ruts, rocks, hidden objects or bumps which could cause you to slip or
trip. Tall grass can hide obstacles.
