XK3190-A28E
- 7 -
5. [*] key perform “parameter switch” function. Press [*] to enter into next parameter setting state.
III. Weighing Operation
1. ZERO:
Press “ZERO” key to return the data to zero. Make sure the data is within zero setting range of the indicator.
Zero setting can be performed only after the STABLE light is on.
2.
TARE
When the displayed weight in weighing state is positive and the” STABLE” light is on, press the “TARE” key to
deduct the indicated weight (as the tare). In this case, the indicator will show a net weight of "0" and the NET
WEIGHT light is on. Press the “TARE” key again when gross weight is 0, the indicator will clear the tare value.
【
note
】
Tare function does not work when the gross weight data is negative
3.
INNER CODE CHECKING
Under the normal weighing state ,F9=2, shortly press
【
Function
】
key, the indicator shows inner code, and press
【
Clear
】
to exit. This code only for testing purpose
4.
PEAK VALUE HOLD, AVERAGE VALUE:
Set F7 for function selection. then press
【
#
】
to start or stop this function. For example:
Choose F7 to “ 2”, press[#], the average value light is on, the indicator will calculate automatically and Lock
weight, the buzzer rings; When the weight changes too much, the indicator will be unlocked, after
re-calculating the weight, the weight will be locked again, meanwhile the buzzer rings. After the weighing
products come down from the scale, the weight will be back to Zero and unlocked . Go circulation for the
weighing. Set F6 to 1, adjust stable range, the lower the value, more accurate the final displayed value is, while
it requires longer time to get stable; the higher the value, the less accurate the final displayed value is, while it
requires shorter time to get stable.
Set F7 to 3, press [#] under the weighing state, the peak value light is on and indicates peak value. It will keep
the maximum weighing data. When weight is back zero, the data is unlocked.
For above operations, press
【
#
】
anytime to exit the average value/peak value status; Press
【
#
】
for every start
of indicator
5.
Manual accumulation of measured value:
Press
【
ACCUM
】
when the measured value is not less than 20 divisions and the data is stable in the normal
weighing state, the indicator will perform "manual accumulation" function. In this case, the indicator will
indicate the total accumulation data (in two steps): [total =] (indicating that the content shown below is the
amount of accumulation data) will show the accumulation data
【
******
】
in about 1 second. The times of
accumulation will be then indicated (in two steps): [n = ] (indicating that the times is shown below) will show
the times of accumulation
【
***
】
in about 1 second. The
【
ACCUM
】
indicating light is then on.
Note: the maximum time of accumulation is 9999 (when
accumulation
result is ensured to be
≤999999); the
accumulation
results will be held before they are cleared and the data will not be lost
