Replacing Oil
Refer to Filling With Lubricating Oil - SD20,
SD50 and SD50-4T on page 19.
Fastest way: By using MerCruiser pump
or simple market pump
Refer to Preparing the Sail-Drive on page
42.
(1)
0005575
Figure 8
1 – Plug
1. Use a MerCruiser
®
pump like the one
shown (Figure 8) or use a similar pump
available locally.
2. Attach the pump to a new bottle of
Quicksilver
®
High Performance Gear
Lube from MerCruiser
®
.
3. Connect the hose with a hose clip to the
adapter joint below the shift lever.
4. Remove the plug from the upper case
cover (Figure 8, (1)).
5. Operate the pump to fill the Sail-Drive
with oil. After bottle is empty, change the
bottle while the pump and hose remain
connected to the adapter joint.
6. After filling, first screw in and tighten the
plug at the top cover (Figure 8, (1)).
Then remove the oil bottle, pump, hose
and adapter joint and screw in the oil
plug with a gasket.
Using Yanmar Hand Pump
0005456
(1)
Figure 9
1 – Plug
PERIODIC MAINTENANCE
44
SD Operation Manual
© 2009 Yanmar Marine International
