Page 1
Electronic Control System: Installation Manual for BY Series Engines with Classic Controls
Checkout and Operation
For complete operating instructions see the Operators Manual, part number MANOPBYCM01.
WARNING
The boat will start to move during the next steps.
Be very cautious when first engaging the gears to establish that forward is truly forward
and reverse is truly reverse. A quick in-and-out of gear test is recommended.
Ensure that the boat is clear of all obstacles forward and aft before conducting this test.
Start the Engine
•
Connect the safety lanyard to your person.
•
Move the control handle to the NEUTRAL position.
•
Turn the key switch to the ON position.
•
Turn and hold the key switch at the START position until engine starts.
•
When the engine is running allow the key switch to return to the ON position.
The tachometer will indicate the idle RPM’s and the boat is ready to operate.
Moving the Boat
Move the control lever from NEUTRAL to a GEAR position. On Side Mount controls it will be necessary to
press the Neutral Interlock button. The boat will move. Pushing the handle past the gear detent will advance
the throttle.
Always operate the boat in a safe manner.
Shut Down
When ready to shut down the engine return the control to NEUTRAL and turn the Key Switch to the OFF
position. This will stop the engine.
* No digital value will be displayed for these parameters on Classic Systems.
Tachometer Display
The digital display on the tachometer shows a variety of engine data. The operation of the display is shown on
the next pages. All of the items listed here may be seen on the tachometer’s digital display.
Data
RPM
Battery Voltage
Coolant Temperature
Boost Pressure
Engine Load
Fuel Rate
Engine Hours
* Fuel Level
* Oil Pressure
Alarms
Check Engine Alarm
Over Temp Alarm
Low System Voltage Alarm
High Boost Pressure Alarm
Throttle Position Sensor Alarm
Neutral Start Protect Alarm
