SA221/324/424 Operation Manual
10.Turn the starter key switch to the
preheating position to energize the
glow plug and preheat the engine
(A) Preheating position
(B) START position
Preheating time should be determined according to
the ambient temperature. For details, see the table
below.
(A) Engine oil pressure warning light
(B) Alternator/Battery charging light
11.Turn and hold the starter key switch
to the START position
IMPORTANT
●
If the engine oil pressure light fails to turn OFF
within 5 seconds after the engine is started:
• shut off the engine and check for the cause
●
If no specific cause is detected, but a problem still
persists:
• contact YOUR LOCAL YANMAR TRACTOR
DEALER for technical assistance
NOTE
●
If the key is released before the engine started:
• wait until both the starter and engine stop
rotating before trying to start the tractor again
Ambient Temperature
(°F (°C))
Preheating Time (sec.)
Over 32 (0)
2 to 3
Below 32 (0)
4
NOTE
●
While the starter key switch is in the preheating
position. The engine oil pressure warning light
and the alternator/battery charging light
illuminates.
(A)
(B)
NOTE
●
Once the engine is running, release the starter
key switch.
●
If the key is released before the engine started:
• wait until both the starter and engine stop
rotating before trying to start the tractor again
IMPORTANT: Avoid damage!
●
Continuous activation of the starter for more than
15 seconds can damage the starter.
●
If the engine fails to start within 15 seconds,
discontinue activating the starter.
●
Wait for 2 minutes before trying to restart the
engine.
●
After the engine has started, warm up the engine
for 5 minutes at 2000 to 2400 min
-1
(rpm) without
any load.
(A)
(B)
SA221_324_424_OperatorsManual.book 6 ページ ２０１８年６月４日 月曜日 午後５時１９分
