ALTERNATOR
11-20
3TNV88F Service Manual
Dynamo
3. Reinstall the front bearings
4. Reinstall the flat washer
(Figure 11-28, (4))
,
(Figure 11-28, (3))
, pulley half
, and through bolt
.
Figure 11-28
5. Reinstall the flat washer
(Figure 11-29, (4))
,
, and nut
. Tighten the nut to the
specified torque.
6. Reinstall the rear cap
(Figure 11-29, (1))
.
Figure 11-29
Installation of Dynamo
1. Position the dynamo on the gear case. Loosely
reinstall the nut
on the gear
case stud and the V-belt adjuster bolt
(Figure 11-30, (1))
.
Figure 11-30
2. Reconnect the dynamo output wire connector.
3. Reinstall the V-belt. Tighten the V-belt to the
proper tension as described in
adjust cooling fan V-belt on page 5-9
.
4. Start the engine. Listen for any unusual sounds
from the alternator.
NOTICE
Do not operate the engine if the alternator is
producing unusual sounds. Damage to the
alternator will result.
5. Verify that the charge indicator is ON while the
engine is operating. If the charge indicator is
not ON, repair the problem before operating the
engine.
K0002144X
6
5
4
3
2
1
K0002143X
1
2
3
4
K0002141X
1
2
3TNV88F_SVM_A4.book 20 ページ 2012年7月26日 木曜日 午後6時4分