Yanmar 2V Series, Operation Manual

Page: 40 / 112

PRODUCT OVERVIEW
24
2V Operation Manual
Engine Stop Solenoid
When the key is turned to the START position, the
engine stop solenoid
(Figure 3, (1)) is energized
and allows the fuel injection pump to deliver fuel to
the engine, allowing the engine to be started. When
the key is turned to the ON position, the stop
solenoid remains energized and the engine
continues to run. When the key is turned to the OFF
position, the engine stop solenoid is de-energized
and shuts off the fuel supply from the fuel injection
pump to the engine, causing the engine to stop.
Figure 3
Governor Lever
0002626B
(1)
CAUTION
NEVER attempt to adjust the low or high
idle speed limit screw. This may impair
the safety and performance of the
machine and shorten its life. If
adjustment is ever required, contact
your authorized Yanmar industrial
engine dealer or distributor.
0000045en
CAUTION
• NEVER remove or attempt to remove
the tamper-proof devices from the full-
load fuel adjusting screw or the high-
speed throttle limit screw on the fuel
injection pump and governor
assembly. These adjustments have
been made at the factory to meet all
applicable emissions regulations and
then sealed.
• NEVER attempt to make any
adjustments to these sealed
adjustment screws. If adjustments are
required, they can be made only by a
qualified fuel injection shop that will
ensure the injection pump continues
to meet all applicable emissions
regulations and then replace the
tamper-proof seals.
• Tampering with or removing these
devices may void the “Yanmar Limited
Warranty.”
0000146en