YZ-S5
7
3.3 Precautions for machine operation
●Avoid stopping the machine and rolling the brush in the same place for a long time;
this will leave unnecessary marks on the ground.
●If you need to collect large light garbage, you can lift the front cover by stepping on
the pedal to allow the large light garbage to pass through the machine. Please
remember that when the front cover is raised, the amount of dust in the machine will
be reduced
●In order to clean the machine well, be sure to clean the filter screen, stop the
machine, press the dust vibration switch, and start the dust vibration motor to vibrate
the filter within 1 minute. After cleaning the filter, restart the sweeping operation.
●When working, the filter needs to be vibrated every 30 minutes on average.
(depending on the garbage in the area to be cleaned)
●When the filter screen is blocked or the garbage bin is full, the machine cannot
collect garbage and should not work on wet ground to avoid damage to the filter
screen.
●The rubbish bin must be emptied every time the work is completed or the rubbish bin
is full.
Push/drag of the machine
●Push/drag the machine when the machine is off, or when there is a malfunction
Drive the machine to ensure that the speed is not more than 5km/h. Press the button
to forward gear when going forward
position, press the button to reverse when reversing.
After using the machine
●Press the reset button to raise the main and side brushes.
Empty the trash
●Release the pedal to stop the machine.
●The trash can hasp is opened.
●Pull the trash can down and then pull it out to
dump the trash.
●Put the trash can back into the machine and
fasten the hasp of the trash can.
Note: The sealing
strip of the dustbin is tightly fitted with the box body.
●The machine is ready to work again.
Summary of Contents for YZ-S5
Page 1: ...YZ S5 Floor Sweeper operation instructions ...
Page 2: ...YZ S5 Yangzi Make cleaning easier ...
Page 18: ...YZ S5 1 ...
