Yamarin 65 Day Cruiser
27 (40)
Yamarin 65 DC fastening on trailer:
Tie the boat properly before starting the transport. Fastening belts located at the bow should
be directed "down-back" and fastening belts located at rear should be directed "down-front".
Do not leave any loose equipment or extra load to boat when it's transported. Take seat
cushion away and close the hatches properly.
When transporting the boat the motor should be on its driving position. Make sure that there
is the needed road clearance.
The fastening belts must be loosened up if the boat is kept on trailer between transportations
and tightened up before next transportation.
NOTE!
The trailer should be a little front-weighted. Make sure that the
boat is fasten tight enough to trailer and the weight of the boat is
divided equally on the both side supports. If the boat swings
against the side support, it can damage the hull.
When letting down the boat from trailer, remember to fasten the bow rope to the boat in order
to release cable from the trailer hook when boat is on the water. Look out the winch handle!
5.10.7
Docking
The storage cradle should be sufficiently steady and suitable for the boat's dimensions. A
sturdy plank (2x4"), should be placed between the V trestles to support the keel and to bear
most of the weight of the boat. The side supports must not support the boat. The side supports
should have cut outs at the bottom steps to avoid load points on the steps. The supporting
structures at the transom should be strong enough to also support the weight of the engine.
Storage cradle dimensions are shown picture below.
