33
antifouling paint. Carefully follow the paint manufacturer’s instructions when applying the paint.
When sanding old antifouling paint, remember that the dust is toxic.
At lake areas, antifouling is not needed and its use is not recommended.
Perform the necessary service procedures required for the engine according to the engine manual.
Check the functioning of electric equipment and remove possible oxidation from fuse connectors
etc.
When the boat has been launched, you should open all hull bushings and check to ensure that there
are no leaking hoses or connectors. The location of bushings is described in chapter 5. Bring the
safety equipment on board before setting off.
NOTE!
Do not apply any paint to the zinc anodes, log sensor, or piston rods of
hydraulic trim tabs. Do not apply paints containing copper on
aluminium parts, and remember to follow the paint manufacturer’s
instructions.
Useful tip: Do not throw away a used paint brush. A dried and hardened paint brush that has been
used for antifouling paint can be reused if you first soak it for a couple of hours in a mix of 2 litres
of hot water, 100 ml of vinegar, and 50 ml of baking powder.
Remember that petrol goes stale over time, and you must always start the engine with fresh petrol
in the spring.
