Yamaha YZ125X 2023, Owner'S Manual

Page: 80 / 146

HANDLEBAR
4-10
stalled with the punch marks “a” facing for-
ward.
• Install the handlebar so that the marks “b” are
in place on both sides.
• Install the handlebar so that the projection “c”
of the upper handlebar holders is positioned at
the mark on the handlebar as shown.
•
First tighten the bolts on the front side of the
upper handlebar holder, and then tighten the
bolts on the rear side.
4. Tighten:
•
Lower handlebar holder nut “1”
5. Install:
• Left grip “1”
Apply the adhesive to the handlebar “2”.
TIP
•
Before applying the adhesive, wipe off grease
or oil on the handlebar surface “a” with a lac-
quer thinner.
• Install the left grip to the handlebar so that the
line “b” between the two arrow marks faces
straight upward.
6. Install:
• Engine stop switch “1”
•
Clutch lever holder “2”
• Clutch lever holder bolt “3”
•
Clamp “4”
TIP
• The engine stop switch, clutch lever holder and
a
+1
+2
-1
-2
c
Lower handlebar holder nut
40 N·m (4.0 kgf·m, 30 lb·ft)
Engine stop switch screw
0.5 N·m (0.05 kgf·m, 0.37 lb·ft)
Clutch lever holder bolt
5 N·m (0.5 kgf·m, 3.7 lb·ft)
Clutch lever nut
4.0 N·m (0.40 kgf·m, 3.0 lb·ft)
T
R
.
.
T
R
.
.
T
R
.
.