Yamaha YSP 800 - Digital Sound Projector Five CH..., Owner'S Manual

Page: 86 / 101

REMOTE CONTROL FEATURES
82
In addition to controlling this unit, the remote control can also operate other A/V components made by YAMAHA and
other manufacturers. To control other components, you must set up the remote control with the appropriate remote
control codes.
Depending on the external A/V component you are using, you may not be able to operate the component with the remote control, even
if a remote control code is set. In this case, operate the component using the supplied remote control.
You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input area (TV, STB, DVD, VCR and AUX).
For a complete list of available remote control codes, refer
to “LIST OF REMOTE CONTROL CODES” at the end of
this manual.
1
While holding down CODE SET, press the
input selector button
for the component you
want to set up and then without releasing
CODE SET, enter the remote control code
using the numeric buttons.
The following illustrations show an example of
setting the remote control code for a DVD player
made by YAMAHA.
2
Refer to “Controlling other components” on
page 83 to operate the external component
using the remote control.
If the external component functions correctly, the
remote control code setup was successful.
If the external component does not function correctly,
the remote control code may be incorrect. Confirm
that the remote control code is correct (see “LIST OF
REMOTE CONTROL CODES” at the end of this
manual) and start over from step 1.
If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
REMOTE CONTROL FEATURES
Note
Setting remote control codes
2
1
STEREO
SLEEP
CH LEVEL MENU
RETURN TEST
TV VOL VOLUME
MUTE TV INPUT TV MUTE
ENTER
SURROUND OFF
CODE SET
SPORTS
3
4 5 6
7 8 9
0 +10
5BEAM ST+3BEAM 3BEAM
TARGET
MUSIC MOVIE VOL MODE
INPUTMODE ( )
MACRO INPUT2 INPUT1
TV STB VCR DVD
AUX
YSP
CINEMA DSP
CH
TV
Note
If the remote control is without batteries for more than
2 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. When the memory is cleared, insert new
batteries and reset the remote control codes.
When changing the batteries, be careful not to press
any of the buttons on the remote control. Doing so will
clear the contents of the memory.
TV MUTE
CODE SET
DVD
6
9
9
VOL MODE
VOL MODE
While holding
down, press
Setting example: YAMAHA DVD input area