66
MANUAL SETUP
• Select ANGLE TO WALL OR CORNER if this unit is
installed in the corner in your listening room. Adjust
the width and length of your listening room as well as
the distance of the listening position from this unit and
the distance of the center of this unit from the left wall.
Choices for the room width and length:
2.0 m to 12.0 m (6.5 ft to 40.0 ft)
Choices for the listening position from this unit:
2.0 m to 9.0 m (6.5 ft to 30.0 ft)
Choices for the listening position from the left wall:
0.6 m to 11.4 m (2.0 ft to 38.0 ft)
When you set the INSTALLED POSITION parameter in BASIC
SETUP (see page 59) or MANUAL SETUP (see page 65), the
parameters newly set for the width and length of your listening
room are automatically set as the factory default value.
■
BEAM ADJUSTMENT (Beam adjustment)
Use to manually adjust the various speaker beam angles.
We recommend that you select 5 beam mode before
adjusting these parameters.
• When INSTALLED POSITION is adjusted in BASIC SETUP
(see page 59) or MANUAL SETUP (see page 65), the factory
default value is automatically set for this parameter except when
FOCAL LENGTH is set to CENTER (see page 67).
• Depending on the beam mode settings (see page 40), some
speaker positions may not be available for selection. In this
case, “– –” is displayed. When using the stereo plus 3 beam
mode, set the surround left and right signals to be output from
the front left and right speakers.
HORIZONTAL ANGLE (Horizontal angle)
Use to adjust the horizontal angle of beams for each
speaker. By adjusting the horizontal angle of the beams,
you can optimize the sound beam paths. A test tone is
automatically output.
Choices: L90° to R90°
Adjust towards L (left) to move the direction of the output
to the left and adjust towards R (right) to move it to the
right.
Note
Listening position
from the unit
Room length
Room width
A)SETTING PARAMETERS 2/3
12.0m
12.0m
[]/[]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
p
p
p
p
A)SETTING PARAMETERS 3/3
12.0m
[]/[]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
p
p
p
p
Room width and length
Listening position from
the unit and the left wall
Notes
.
a)HORIZONTAL ANGLE
b)BEAM TRAVEL LENGTH
c)FOCAL LENGTH
d)TREBLE GAIN
[]/[]:Up/Down
[SELECT]:Enter
B)BEAM ADJUSTMENT
p
p
(
−
)
(+)
(+)
(
−
)
a)HORIZONTAL ANGLE 1/5
0(deg)
3BEAM
[]/[]:Up/Down[ ]/[ ]:Sel
[ENTER]:Return
p
p
L90
R90
Front L
L60deg
*
p
p
