Operation an
d
important ri
d
in
g
points
5-1
5
EAU15952
Read the Owner’s Manual carefully to
become familiar with all controls. If
there is a control or function you do not
understand, ask your Yamaha dealer.
WARNING
EWA10272
Failure to familiarize yourself with
the controls can lea
d
to loss of con-
trol, which coul
d
cause an acci
d
ent
or injury.
EAUM3150
TIP
This model is equipped with a lean an-
gle sensor to stop the engine in case of
a turnover. To start the engine after a
turnover, be sure to turn the main
switch to “
” and then to “
”. Failing
to do so will prevent the engine from
starting even though the engine will
crank when pushing the start switch.
EAU78350
Startin
g
the en
g
ine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the
sidestand up.
See page 3-13 for more informa-
tion.
1. Turn the key to “
”.
The engine trouble warning light
should come on for a few sec-
onds, then go off.
NOTICE
ECA23970
If the warnin
g
li
g
ht
d
oes not come
on initially when the key is turne
d
to “
”, or if the warnin
g
li
g
ht re-
mains on, see pa
g
e 3-2 for the warn-
in
g
li
g
ht circuit check.
2. Shift the transmission into the
neutral position. The neutral indi-
cator light should come on. If not,
ask a Yamaha dealer to check the
electrical circuit.
UBT4E0E0.book Page 1 Thursday, November 17, 2016 10:55 AM
