Yamaha YFM660RN, Service Manual, Page: 95 / 328

3 - 39
CHK
ADJ
j. Tighten the bleed screw.
NOTE:
If bleeding is difficult, it may be necessary to
let the brake fluid settle for a few hours.
Repeat the bleeding procedure when the tiny
bubbles in the system have disappeared.
k. Add brake fluid to the proper level.
Refer to “CHECKING THE BRAKE FLUID
LEVEL”.
WARNING
Check the operation of the brake after
bleeding the brake system.
***********************************************
T
R
.
.
Bleed screw:
6 Nm (0.6 m • kg, 4.3 ft • lb)
ADJUSTING THE SHIFT PEDAL
1.Check:
●
Shift pedal height
a
Out of specification
→
Adjust.
Shift pedal height:
22 mm (0.89 in)
2.Adjust:
●
Shift pedal height
***********************************************
Adjustment steps:
●
Loosen the locknuts
1
.
●
Turn the adjusting rod
2
in direction
a
or
b
until the specified shift pedal position
obtained.
●
Tighten the locknuts.
***********************************************
Direction
a
Shift pedal position is
down.
Direction
b
Shift pedal position is
up.
T
R
.
.
Locknut:
8 Nm (0.8 m • kg, 5.8 ft • lb)
BLEEDING THE HYDRAULIC BRAKE SYSTEM/
ADJUSTING THE SHIFT PEDAL