– 26 –
CHK
ADJ
ADJUSTING THE SELECT LEVER CONTROL CABLE AND SHIFT
ROD/ADJUSTING THE HEADLIGHT BEAM/
REPLACING A HEADLIGHT BULB
e. Check that locknuts
2
are tightened cor-
rectly.
f. If the operation of the select lever is incor-
rect, adjust the select lever control cable
3
with the adjuster
4
.
2
3
4
Select lever shift rod:
a. Make sure the select lever
1
is in FOR-
WARD.
b. Loosen the locknuts
2
.
c. Turn the select lever adjusting nut
3
in or
out until lever
4
center line
a
aligns with
match mark
b
on the crankcase cover.
d. Tighten the locknuts
2
.
NOTE:
After adjusting the drive select lever, be sure
the reverse indicator light comes on when the
drive select lever is in reverse position.
▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
T
R
.
.
Locknut (select lever adjuster)
15 Nm (1.5 m · kg, 11 ft · lb)
1
2
3
4
ADJUSTING THE HEADLIGHT BEAM
1. Adjust:
• headlight beam (vertically)
Turn the adjusting screw
1
in or out.
Turning in
Headlight beam raised.
Turning out
Headlight beam lowered.
REPLACING A HEADLIGHT BULB
1. Remove:
• cover
1