9-12
9
5. If the engine oil is at or below the minimum
level mark, add sufficient quantity of the rec-
ommended engine oil.
NOTICE:
Be sure the
engine oil is at the correct level, otherwise
engine damage may result.
[ECB00852]
6. Check the O-ring for damage, and then insert
the dipstick and tighten the engine oil filler
cap.
To change the engine oil
1. Park the ATV on a level surface.
2. Start the engine, warm it up for several min-
utes, and then turn it off.
3. Place an oil pan under the engine to collect
the used oil.
4. Remove the engine oil filler cap, and then re-
move the engine oil drain bolt to drain the oil
from the crankcase.
NOTICE:
When remov-
ing the engine oil drain bolt, the compres-
sion spring, oil strainer and O-ring will fall
out. Take care not to lose these parts.
[ECB00312]
5. Clean the oil strainer with solvent.
6. Discard the old engine oil drain bolt O-ring,
and then apply a thin coat of clean engine oil
to the new O-ring.
7. Install the oil strainer, the compression
spring, the new O-ring and the engine oil
drain bolt. Tighten the engine oil drain bolt to
the specified torque.
NOTICE:
Before in-
stalling the engine oil drain bolt, be sure to
install the O-ring, compression spring and
oil strainer.
[ECB00322]
1. Engine oil drain bolt
2. O-ring
3. Compression spring
4. Oil strainer
4
3
2
1
UB8W12E0.book Page 12 Wednesday, January 22, 2020 2:13 PM
