INSTALLING THE INCLUDED PARTS
– 11 –
79
E. The minutes value increases when the “
▲
”
assist mode switch
f
is pressed while the “Min-
ute” section of the clock
e
is flashing.
The minutes value decreases when the “
▼
”
assist mode switch
d
is pressed.
Press the function select switch
b
to set the
minutes.
F. The time is set and the mode returns to the nor-
mal mode.
TIP
If you make a mistake adjusting the time, start over
from step B.
G. Press the power switch
a
to complete adjust-
ment of the time.
13. Checking the operation of the speed sensor
A. Press the power switch
a
to turn on the power.
B. Long-press the power switch
a
(approximately
10 seconds) within 30 seconds after turning on
the power, check that the display switches to the
diagnosis function selection screen
b
, then
release the power switch
a
.
C. Press the “
▼
” assist mode switch
c
, display
“SPEED SNSR” on the diagnosis function
selection screen
b
, then press the function
select switch
d
to set.
D. Check that the speedometer
e
is displayed and
that the speed sensor checking mode has been
set.
E. The number displayed on the speedometer
e
counts up when the rear wheel is lifted off the
ground and turned.
The number increases by 1 for 1 turn. Check
that the position of the wheel at which the dis-
play counts up is stable.
F. After checking the operation, press the power
switch
a
to quit.
TIP
Turn the rear wheel at least 3 revolutions and check
that the display reads “3”.
14. Adjusting the opening of the front and rear
brake levers
Before adjusting the opening of the brake
levers, grip the brake levers approximately 10
times to pump them.
Turn the adjusting screw
1
to adjust the open-
ing of the tip of the brake lever
a
from the tip of
the grip.
f
b
a
e
d
d
a
b
c
a
e
a
b
c
1
b
direction
Opening gets larger.
c
direction
Opening gets smaller.
