En
15
How to mount the unit on the wall
1 Attach the mounting template on a wall and mark for the
screw holes.
2 Remove the mounting template from the wall, then install
commercially available screws (as illustrated below) at the
points marked on the wall.
3 Peel off the backing paper from the spacers and attach the
adhesive face to the unit as illustrated below.
4 Hang the unit on the screws.
Cautions
• When mounting the unit on a wall, all installation work must be performed by a
qualified contractor or dealer. The customer must never attempt to perform this
installation work. Improper or inadequate installation could cause the unit to fall,
resulting in personal injury.
• To prevent the unit from falling, attach it to a wall constructed of drywall
(plasterboard).
• Make sure you use commercially available screws that can support the weight of
the installation (specified in Step 2 on the right). Using clamps other than
specified screws, such as short screws, nails, and two-sided tape, may cause
the unit to fall.
• Fix the cables in place where they will not become loose. If your foot or hand
accidentally gets caught on a loose cable, the unit may fall.
• Do not lean on the unit or apply excessive force to the top of the unit. Doing so
may cause the unit to fall.
• Check that the unit is fixed securely after the installation. Yamaha will bear no
responsibility for any accidents caused by improper installations.
Tapes or thumbtacks
Mounting template (supplied)
Screw
holes
7 to 9 mm
(1/4" to 3/8")
13 to 15 mm (1/2" to 5/8")
4 mm (#8)
20 mm (3/4")
or more
Spacers
Mounting holes
on bottom of the
unit
